Software-update: Cura 5.7.2

Cura wordt ontwikkeld door UltiMaker om 3d-printen zo gemakkelijk en gestroomlijnd mogelijk te maken. Cura bevat alles wat je nodig hebt om een 3d-bestand te kunnen printen. Het werkt met alle UltiMaker-printers, maar ook met die van RepRap en Printrbot. Cura laat zich gemakkelijk installeren en bevat zowel de laatste firmware als de kalibratiebestanden voor de 3d-printer. Versie 5.7.2 van Cura is uitgekomen en hierin zijn de volgende verbeteringen aangebracht:

Bugfixes

Fixed a bug where modifier meshes and support meshes were not loaded in the correct position, should resolve #18761 (and 5axes/SpoonAntiWarping#8)Primeblobs were not printed for a second extruderInterleaved prime tower can now be printed with a raftImproved behaviors for start temperature for multiple extrudersImproved preheating logic when using a raft with multiple extrudersEnabled Raft Remove Inside Corners and Prime Tower Mode to be shipped with a material profile

Fixed a bug where modifier meshes and support meshes were not loaded in the correct position, should resolve #18761 (and 5axes/SpoonAntiWarping#8)

Primeblobs were not printed for a second extruder

Interleaved prime tower can now be printed with a raft

Improved behaviors for start temperature for multiple extruders

Improved preheating logic when using a raft with multiple extruders

Enabled Raft Remove Inside Corners and Prime Tower Mode to be shipped with a material profile

Source: Tweakers.net