Software-update: FreeCAD 1.0.2

Versie 1.0.2 van FreeCAD is uitgekomen. FreeCAD is een gratis en opensource Computer Aided Design-programma en is primair bedoeld voor werktuigbouwkundige ontwerpen, maar kan ook prima voor elektronische ontwerpen of in de architectuur worden gebruikt. In deze tweede update voor versie 1.0 zijn de volgende veranderingen en verbeteringen aangebracht:

FreeCAD 1.0.2 released

We’ve just released a new update with over 30 bugfixes and small improvements, go get it here. As a reminder, these 1.0.X releases bring added stability to version 1.0 of FreeCAD, whereas new features in development will be released in version 1.1. Here are the main changes in v1.0.2:

DraftAssemblyTechDraw

Fixed a dimension alignment issue.FillTemplateFields.csv updated to work with newer templates.

Fixed a dimension alignment issue.

FillTemplateFields.csv updated to work with newer templates.

CAMBIM

BIM_Leader would create a wire with fewer than 2 points.BIM_WPView did not work properly due to a faulty import.Roof would not auto-limit run length (#21796)Collapsing Building container with Level inside would fail in Strict IFC mode (#21912).Arch_Level and Arch_Wall would disappear during the conversion to the Strict IFC mode (#21400).

BIM_Leader would create a wire with fewer than 2 points.

BIM_WPView did not work properly due to a faulty import.

Roof would not auto-limit run length (#21796)

Collapsing Building container with Level inside would fail in Strict IFC mode (#21912).

Arch_Level and Arch_Wall would disappear during the conversion to the Strict IFC mode (#21400).

GUI

Source: Tweakers.net