Firmware-update: SmartEVSE 3.7.3
Als je zelf een laadpaal voor de elektrische auto in elkaar wilt knutselen, kun je meestal een hoop geld besparen. In dat geval heb je onder meer een controller nodig, bijvoorbeeld de opensource EVSE van fabrikant Stegen. Een randapparaat voor de SmartEVSE controller is de Sensorbox: dit is een kastje dat de P1-telegrammen van je electriciteitsmeter vertaalt naar modbus-berichten, op basis waarvan de SmartEVSE zijn laadvermogen regelt. Voor diegenen die geen P1-aansluiting op hun electriciteitsmeter hebben zijn er ook aansluitingen voor CT-klemmen aanwezig op de Sensorbox.
Door een goede samenwerking tussen community en fabrikant worden de communityversies na verloop van tijd overgenomen door de fabrikant, als de stabiliteit in de community is bewezen. Versie 3.7.3 is uitgekomen en hierin zijn de volgende veranderingen en verbeteringen aangebracht:
Changes:
In Solar mode, prevent switching off when StartCurrent would immediately restart Solar charging, thx to BoboschAdded LCDlock, so you can lock the keys below the LCDscreen; also added this to the REST APIToggle LCDlock using o and > buttons at powerupAdded help texts to webserver screen when hovering with mouseOCPP: Enable backlight when presenting RFID tagOCPP: if UID bytes 5 and later are zero, assume 4 byte UIDInvert power measurement when receiving currents for Inverted Eastron, and display values correctly, thx to PimDoosImprove error handling in setTimeZone; check multiple websites to determine locationFix Stop charging if Capacity is reached and timer is not setFix slave not receiving modbus infoFix disconnect MQTT when changing its paramsFixed bug, now we store Daily Repeat correctly in memoryFix RFID EnableOne option: write the 16bits CardOffset value to 16bit NVS key
In Solar mode, prevent switching off when StartCurrent would immediately restart Solar charging, thx to BoboschAdded LCDlock, so you can lock the keys below the LCDscreen; also added this to the REST APIToggle LCDlock using o and > buttons at powerupAdded help texts to webserver screen when hovering with mouseOCPP: Enable backlight when presenting RFID tagOCPP: if UID bytes 5 and later are zero, assume 4 byte UIDInvert power measurement when receiving currents for Inverted Eastron, and display values correctly, thx to PimDoosImprove error handling in setTimeZone; check multiple websites to determine locationFix Stop charging if Capacity is reached and timer is not setFix slave not receiving modbus infoFix disconnect MQTT when changing its paramsFixed bug, now we store Daily Repeat correctly in memoryFix RFID EnableOne option: write the 16bits CardOffset value to 16bit NVS key
Source:
Tweakers.net