Software-update: Cura 5.3.1

Cura wordt ontwikkeld door Ultimaker om 3d-printen zo gemakkelijk en gestroomlijnd mogelijk te maken. Cura bevat alles wat je nodig hebt om een 3d-bestand te kunnen printen. Het werkt met alle Ultimaker-printers, maar ook met die van RepRap en Printrbot. Cura laat zich gemakkelijk installeren en bevat zowel de laatste firmware als de kalibratiebestanden voor de 3d-printer. In versie 5.3.1 zijn de vertalingen bijgewerkt en zijn er diverse problemen verholpen.

Changes in UltiMaker Cura version 5.3.1

Restored and updated translations for 11 languagesFixed a bug where the machine definitions could not be updatedFixed a bug where part of the model would not have fuzzy skinFixed a bug where a project files that contain an intent profile would not load correctlyFixed a bug where Pause At Height was not working correctly for Griffin (UltiMaker printers)Fixed a bug where slicing was blocked if initial printing temperature was higher than the printing temperatureFixed a bug where Gcode would display NOMESH instead of NONMESHFixed a bug where users were unable to slice with certain materials

Restored and updated translations for 11 languages

Fixed a bug where the machine definitions could not be updated

Fixed a bug where part of the model would not have fuzzy skin

Fixed a bug where a project files that contain an intent profile would not load correctly

Fixed a bug where Pause At Height was not working correctly for Griffin (UltiMaker printers)

Fixed a bug where slicing was blocked if initial printing temperature was higher than the printing temperature

Fixed a bug where Gcode would display NOMESH instead of NONMESH

Fixed a bug where users were unable to slice with certain materials

Source: Tweakers.net